Table of Contents
Advertisement
87076_1.book Page 41 Monday, March 10, 2008 9:21 AM
Chapter 3: Commissioning & Setup
Ensure you have sufficient sea room to complete the AutoLearn, then carry out the
AutoLearn as follows:
1. If you are not already in Seatrial calibration:
i.
From Standby mode, hold down
to see the SEATRIAL CAL screen.
ii. Press
iii. Press
2. In Seatrial calibration, press
displayed.
Enter Seatrial calibration
Prepare for AutoLearn
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
auto
to enter Seatrial calibration.
disp
four times to see the AUTOLEARN screen.
disp
as necessary, until the AUTOLEARN screen is
2 sec
x4
CHECK!
Before proceeding, ensure
you have sufficient clear
sea space
1 minute
(approximately)
standby
for 2 seconds, then press
x2
AutoLearn in progress
Start
AutoLearn
41
D5495-2
disp
twice
D9330-1
Advertisement
Table of Contents
