What To Do If - Miele KM 3010 Operating And Installation Instructions

With the aid of the following guide, minor problems can be easily corrected
without contacting Miele.
If having followed the suggestions below, you still cannot resolve the problem,
please contact Miele (see end of this booklet for contact details).

Danger of injury. Installation, maintenance and repairs to electrical appli-
ances must only be carried out by a suitably qualified and competent person in
strict accordance with current local and national safety regulations.
Do not open the casing of the appliance.
Repairs and other work by unqualified persons could be dangerous and Miele
cannot be held liable for unauthorised work.
Problem
The burners do not ig-
nite when the hob is be-
ing used for the first
time or after it has been
out of use for a longer
period.
The burner does not ig-
nite after several at-
tempts.
The gas flame goes out
after being lit.
Cause and remedy
There could be air lock in the gas pipe.
 You may need to make several attempts before the
burner ignites successfully.
There may be a technical fault.
 Turn all of the controls clockwise to "" and inter-
rupt the power supply to the hob for a few
seconds.
The burner is not correctly assembled.
 Assemble the burner correctly.
The gas shut-off valve is closed.
 Open the gas shut-off valve.
The burner is wet and/or dirty.
 Clean and dry the burner.
The flame slits are blocked and/or wet.
 Clean and dry the flame slits.
The flames do not touch the thermocouple and the
burner does not get hot enough:
The burner parts are not positioned correctly.
 Position the burner parts correctly.
There is soiling on the thermocouple.
 Remove any soiling.
What to do if ...
33