Supermicro SuperServer E200-8D User Manual page 32

SuperServer E200-8D User's Manual
Standby Power
The Standby Power header is located at JSTBY1 on the motherboard.
Speaker
On the JD1 header, pins 1-3 can be used for the power LED while pins 4-7 can be used for
an external speaker.
I-SGPIO1/I-SGPIO2
Two Serial Link General Purpose Input/Output (SGPIO) headers are used to communicate
with the enclosure management chip in the system.
NVMe I2C Header
Connector JNVI2C is a management header for the Supermicro AOC NVMe PCI-E peripheral
cards. Connect the I
Standby Power
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 No Connection
Speaker Connector
Pin Definitions
Pin# Definition
1-3 Power LED
4-7 Speaker
Serial Link General Purpose
Headers Pin Definitions
Pin# Definition
1 NC
3 Ground
5 Load
7 Clock
C cable to this connector.
2
Pin Definition
2 NC
4 DATA Out
6 Ground
10 NC
32