Auxiliary Connector; Figure 15: Cp80 Auxiliary Connector; Figure 16: Cp90 Auxiliary Connector - Optronis CP80-3-M/C-540 User Manual

5.1.4 Auxiliary Connector

Auxiliary connector is used to access camera Sync In and Sync Out IOs and for firmware updates.
The connector is labelled "A" for CP80 and "Aux" for CP90.
Camera accessory "Pigtail cable" gives user 2 x 50 ohm BNC connectors to access Sync IN and Sync Out
signals.
Camera accessory "Programming cable" allows an USB connection to a PC for firmware updates.
CP80 Series
Connector info:
Camera (A) connector type:
•
LEMO EGG.0B.304CLL
Cable Connector:
•
LEMO FGG.0B.304.CLAD56Z
Connector View:

Figure 15: CP80 Auxiliary Connector

Connector Pinout:
Pin 1: Sync IN External Synchronization Input.
TTL level:
< 0,8 Volt (low)
> 2 Volt (high)
Pin 2: Reserved
Pin 3: GND Ground
Pin 4: Sync Out External Synchronization
Output.
TTL level @ high impedance,
0 to 2 Volt @ 50 Ohm.
Connector info:
Camera (Aux.) connector type:
•
Cable Connector:
•
Connector View:
]
Connector Pinout:
Pin 1: Sync IN
Pin 2: Reserved
Pin 3: Sync Out
Pin 4, 5, 6: GND
-23-
CP90 Series
Hirose HR10A-7R-6S
Hirose HR10A-7R-6P

Figure 16: CP90 Auxiliary Connector

External Synchronization Input.
TTL level:
< 0,8 Volt (low)
> 2 Volt (high)
External Synchronization Output.
TTL level @ high impedance,
0 to 2 Volt @ 50 Ohm.
Ground