Auxiliary Connector; Figure 11: Cp70 Auxiliary Connector - Optronis CP70-2-M User Manual

5.1.4 Auxiliary Connector

Auxiliary connector is used to access camera Sync In and Sync Out IOs and for firmware updates.
The connector is labelled "Aux" for CP70.
Camera accessory "Pigtail cable" gives user 2 x 50-ohm BNC connectors to access Sync IN and Sync Out
signals.
Camera accessory "Programming cable" allows an USB connection to a PC for firmware updates.
CP70 Series
Connector info:
Camera (A) connector type:
•
Hirose HR10A-7R-6S
Cable Connector:
•
Hirose HR10A-7P-6P
Connector View:

Figure 11: CP70 Auxiliary Connector

Connector Pinout:
Pin 1: Sync IN External Synchronization Input.
TTL level:
< 0,8 Volt (low)
> 2 Volt (high)
Pin 2: Reserved
Pin 3: Sync Out External Synchronization
Output.
TTL level @ high impedance,
0 to 2 Volt @ 50 Ohm.
Pin 4,5,6: GND Ground
-24-