Table of Contents
Advertisement
Programmable Output (PO)
(3) TBD.
Synchronization Output (SO)
(3) Gives out a TTL signal synchronous to the exposure time of the images.
The TTL signal is always active.
Firmware Slot (FW)
(4) Micro SD Card slot with Firmware of the camera. "Major" firmware
updates need to replace the MicroSD card inside the slot.
GigE / USB2 Connector
(5) The GigE Connector is used to communicate with a PC. Please use Cat6
(or better) Patchcable between camera and PC.
The USB2 connector is used for Wi-Fi connection with an Android tablet
(USB2 Wi-Fi dongle) or for configuring camera network setting and firmware
update (USB2 stick).
HDMI Connector
(6) The cameras show live images on the HDMI Connector during "Live
Mode" and during "Recording Mode" This allows to optimize operating
conditions of the application as e.g. illumination condition or lens condition
as e.g. focus, iris and magnification.
Power Connector
(7) The camera is supplied by a 12 Volt DC power source which is delivered
by the camera power supply. To operate the camera, the power supply has
to be connected and the Power Switch has to switch on "1".
Remark:
Please always use the power supply that is foreseen for the camera. When
the camera shall be supplied by another power source please contact first
Optronis GmbH.
SSD Slot Mounting Screw
(8) Please switch off the camera and turn the SSD Slot Mounting Screw
anti-clockwise to open the SSD slot of the camera.
CamRecord CR-S3500
Ref. 1900-SU-02-C
Page 19
Advertisement
Table of Contents
