Configuring Setup Setting; Port Settings - D-Link DES-1226G Manual

Configuring Setup Setting

There are four items, including Port Settings, VLAN Settings, Trunk Settings and Mirror Settings in Setup menu.

Port Settings

The Port Settings menu page (Figure 11) displays each port's status. Click on the ID parameter to set each port's Speed, Flow Control, QoS priority,
and Link Status. When you need to renew the posted information, press the "Refresh" button.
The Link Status in the screen will show the connection speed and duplex mode. This dialog box will display down when the port is disconnected.
Note:
1. Be sure to reset the Gigabit port when transferring the media type ( Fiber to Copper or Copper to Fiber ).
2. The priority of Gigabit Fiber port is higher than Copper.
To change the port setting, click on the ID parameter to enter the selected port to configure its Speed/Disable, Flow control, and QoS settings.
Speed/Disable:
This setting has six modes—100M Full, 100M Half, 10M Full, 10M Half, Auto, and Disable—for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable to avoid data transfer overflow. It is set to
Disable when there is either no flow control or other hardware/software management.
When the port is set to forced mode, the flow control will automatically be set to Disable.
QoS:
Figure 11. Port Configuration
Figure 12.
14