10/100/1000BASE-T Twisted Pair Ports (Port 25~26)
The DES-1226G is equipped with two Gigabit twisted pair ports that are auto negotiable 10/100/1000Mbps and
also support auto MDI/MDIX crossover detection. These two ports can operate in half- and full- duplex modes.
SFP(Mini GBIC) Ports (Option Port 25~26)
The Switch is equipped with two SFP(Mini GBIC) ports, supported optional 1000BASE-X SFP(Mini GBIC)
module.
Note: When the port is set to "Forced Mode", the Auto MDI/MDIX will be disabled.
Rear Panel
AC Power Connector
This is a three-pronged connector that supports the power cord. Plug in the female connector of the provided
power cord into this connector, and the male into a power outlet. Supported input voltages range from
100~240V AC at 50~60Hz.
Reset
The Reset button is to reset all the settings back to the factory defaults.
Note: Be sure that you record the settings of your device, or else all settings will be erased when pressing the
"Reset" button.
3.
Installation
The site where you place the DES-1226G may greatly affect its performance. When installing, take the following into
your consideration:
Install the DES-1226G in a fairly cool and dry place. See the Technical Specifications for the acceptable
temperature and humidity operating ranges.
Install the DES-1226G in a site free from strong electromagnetic field generators (such as motors), vibration,
dust, and direct exposure to sunlight.
Leave at least 10cm (about 4 inches) of space at the front and rear of the Switch for ventilation.
Install the DES-1226G on a sturdy, level surface that can support its weight, or in an EIA standard-size
equipment rack.
When installing the Switch on a level surface, attach the rubber feet to the bottom of each device. The rubber
feet cushion the Switch and protect the Switch case from scratching.
Rack Mounting
The DES-1226G can be mounted in an EIA standard-size, 19-inch rack, which can be placed in a wiring closet with
other equipment. Attach the mounting brackets to both sides of the Switch (one at each side), and secure them with the
provided screws.
●
Reset
button
Attach the adhesive rubber pads to the bottom
7