Installing The Dcs-900 Behind A Router - D-Link SECURICAM Network DCS-900 Manual

DCS-900 Configuration

Installing the DCS-900 Behind a Router

If you are installing a single camera on your network the installation is an easy 4–step
procedure:
1) Identify Your Camera on the Network
2) Assign a Local IP Address for Your Camera
3) Determine Your Router's WAN IP Address (Enable Remote Viewing)
4) Open Virtual Server Ports for Your Router (Enable Remote Viewing)
If you are installing multiple cameras on your network, the installation is an easy 5-
step procedure:
1) Identify Your Camera on the Network
2) Assign a Local IP Address for Your Camera
3) Open a Second Port on the Camera
4) Determine Your Router's WAN IP Address (Enable Remote Viewing)
5) Open Virtual Server Ports for Your Router (Enable Remote Viewing)
Single Camera Installation
Multiple Camera Installation
(continued)
23