Rear Panel View; Network Cable Connector; Dc Power Connector; Reset Button - D-Link SECURICAM Network DCS-900 Manual

Connections
Ethernet Cable
Connector

Reset Button

DC Power Connector

Network Cable Connector

The DCS-900 features an RJ-45 connector for connections to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which should be Category 5 UTP cable). The port
supports the NWay protocol, allowing the DCS-900 to automatically detect or negotiate
the transmission speed of the network.
DC Power Connector
The DC power input connector is labeled DC 5V with a single jack socket to supply
power to the DCS-900.
Reset Button
Reset will be initiated when the reset button is pressed once and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when the Power LED begins to light up. Release the reset button and the
Power LED will begin to flash indicating that the DCS-900's settings are reverting back
to the factory settings. The IP address will also return to the default setting of 192.168.0.20.

Rear Panel view

6