D-Link SECURICAM Network DCS-900 Manual page 13

Using the Setup Wizard
To run the Setup Wizard, click on
Start->Programs->DCS-900 Series
SetupWizard.
Your camera's IP Address will be
displayed here if it is valid.
Click Wizard
to begin
You must change the
Admin ID and Password
immediately to protect your
camera against unauthorized
access. By default, the
Admin ID and Password are
blank. To change the Admin
ID and Password, select both
Change boxes and enter a
New ID and New Password.
Click Next
The IP Address and Subnet
Mask of your camera, Gateway,
and DNS addresses must
correspond with your network
settings for you to access the
camera. If you are unsure of
what these settings should be,
please check with your network
administrator.
Click Next
(continued)
13