Getting Started; Powering On The Unit; Inserting A Disc - CyberHome CH-DVD 300 Operation Manual

Powering on the unit

Only after all connections are complete, connect the power
cord and power on the unit.
1
Plug the standard electrical plug into a wall socket or
power strip.
2
The unit is now in STANDBY MODE. Once the unit has
been turned on, the unit will always be either ON, or in
STANDBY MODE.
3
Press STANDBY on the remote control or front panel to
bring the system out of standby mode. The system is
now ready to use.
TM TM TM TM
CH-DVD 300
POWER SETUP
DISPLAY
MENU GOTO
TITLE
PBC
SUBTITLE
ANGLE AUDIO
Notes on power states
There are three power states for this unit:
OFF - The unit is not plugged into a wall outlet. The unit
draws no power.
STANDBY - The unit is plugged into a wall outlet. The unit
has not been taken out of standby by pressing either the
STANDBY key on the remote control or the ON /
STANDBY button on the front panel. The unit draws a
slight amount of power to enable the remote control
receiving circuit. The standby LED is glowing red.
ON - The unit is plugged into wall outlet and either the
STANDBY button on the remote control or the ON /
STANDBY button on the front panel has been pressed. The
unit is ready to use. The LED is now glowing green.

GETTING STARTED

OPEN/CLOSE
PROGRAM
MUTE

Inserting a disc

1
Press the OPEN/CLOSE button on the remote or front
panel to open the disc tray.
CH-DVD 300
POWER DISPLAY
MENU
TITLE
PBC
SUBTITLE
ANGLE
2
Insert the disc, being careful not to touch the playing
surface. Hold the disc by the sides and with your fore
finger through the hold in the middle and insert gently
into the tray.
3
Close the disc tray by pressing OPEN / CLOSE on the
remote or front panel.
13
TM TM TM TM
SETUP OPEN/CLOSE
GOTO PROGRAM
AUDIO MUTE
Labeling Side
Surface