Windsor Saber SX28 Operating Instructions Manual page 25

MAINTENANCE
TO REPLACE OR ROTATE REAR
SQUEEGEE BLADES
1. With the squeegee in the up position, turn off the
key switch and set the parking brake.
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
2. Unlock and pull open latch on rear of squeegee
tool.
3. Remove blade retainer straps from squeegee
tool.
4. Remove squeegee blade from locating pins on
squeegee tool and rotate to new position or
replace as required.
5. Install blade on locating pins of squeegee tool.
6. Install squeegee retainer straps.
7. Fasten and lock latch. Latch is adjustable.
Adjust latch only tight enough to take up slack in
retaining strap.
NOTE: Changing of squeegee blades does not
always necessitate a readjustment. Refer to section
on adjusting squeegee.
4-7
TO REMOVE SQUEEGEE ASSEMBLY
1. With the squeegee in the up position, turn off the
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
2. Disconnect vacuum hose and loosen the two
3. Pull squeegee assembly rearward from the
4. With squeegee assembly on bench inspect or
5. To reinstall, align squeegee assembly to lift
6. Tighten knobs.
7. Attach vacuum hose.
TO REPLACE OR ROTATE FRONT
SQUEEGEE BLADES
1. With squeegee assembly on bench, release
2. Remove front retainer strap.
3. Remove squeegee blade from locating pins on
4. Install blade on locating pins of squeegee tool.
5. Replace front retainer strap.
6. Secure strap by locking latch.
NOTE: Changing of squeegee blades does not
always necessitate a readjustment. Refer to section
on adjusting squeegee.
SABER 36V (SX) 98739 10/25/99
key switch and set the parking brake.
squeegee retaining knobs.
lifting carrier.
repair as necessary.
carrier. Push forward while keeping squeegee
level.
latch securing retainer strap.
squeegee tool and rotate to new position or
replace as required.