Windsor Saber SX28 Operating Instructions Manual page 16

16. CIRCUIT BREAKERS
Interrupt the flow of power in the event of an
electrical overload. When a circuit breaker is
tripped, reset it by pressing the exposed
button. If a circuit breaker continues to trip,
the cause of the electrical overload should be
found and corrected.
3 Amp. Protects the machine
controls.
30 Amp. Protects the left scrub
brush motor.
30 Amp. Protects the right scrub
brush motor.
25 Amp. Protects the vacuum
motor.
35 Amp. Protects the propel
motor.
17. PARKING BRAKE PEDAL
Locks front wheels to prevent unintentional
movement.
To set parking brake, push down on the foot
pedal.
To release parking brake, pull up on the foot
pedal.
18. SQUEEGEE LIFT LEVER
Raises and lowers the squeegee.
To lower the squeegee, lift the lever from its
raised position.
To raise the squeegee, lift the lever from its
lowered position.
19. SQUEEGEE PITCH ADJUSTMENT KNOB
20. SQUEEGEE DEFLECTION ADJUSTMENT
21. SOLUTION CONTROL LEVER
SABER 36V (SX) 98739 10/25/99
Adjusts the deflection at the ends of the
squeegee.
To increase squeegee blade deflection at the
ends, turn knob counterclockwise.
To decrease squeegee blade deflection at the
ends, turn knob clockwise.
KNOB
Adjusts the deflection along the entire length
of the squeegee.
To increase squeegee blade deflection along
the entire length, loosen knob, slide bar to left
to desired deflection, then tighten knob.
To decrease squeegee blade deflection along
the entire length, loosen knob, slide bar to
right to desired deflection, then tighten knob.
(FOR RECYCLING OPTION ONLY)
Controls solution flow to scrub deck.
To increase flow, push down on lever.
To decrease flow, pull lever up.
CONTROLS
3-8