Windsor Saber SX28 Operating Instructions Manual page 15

CONTROLS
7. KEY SWITCH
Controls the power for machine functions.
To turn machine on, rotate key clockwise.
To turn machine off, rotate key
counterclockwise.
FOR SAFETY: Always remove the key
when machine is unattended or during
service to prevent unauthorized
movement.
8. SPEED CONTROL KNOB
Controls the speed of the machine.
To increase speed, rotate knob clockwise.
To decrease speed, rotate knob
counterclockwise.
9. BATTERY CHARGE LEVEL INDICATOR
Indicates the charge level of the batteries.
The charge level indicator consists of 6 lights.
All 6 lights on indicate a full charge. Only the
left two lights on indicates 80% discharge,
which is the ideal time to recharge batteries.
Only one light on indicates batteries must be
recharged. Further operation of the machine
could damage the machine or the batteries.
When the machine is left overnight with less
than a full charge, the display may initially
indicate a full charge. It will also indicate a full
charge if the batteries are disconnected, then
reconnected. After a few minutes of operation
the meter will give the correct charge level.
10. RECYCLE SWITCH (OPTIONAL)
Controls the solution recycle pump.
To start recycle pump, press the switch.
To stop recycle pump, press the switch.
3-7
11. PUMP SWITCH (OPTIONAL)
12. CONTROL PANEL HEIGHT
13. DIRECTIONAL CONTROL LEVER
14. EMERGENCY SHUT-OFF SWITCH
15. HOUR METER
SABER 36V (SX) 98739 10/25/99
Controls the pump to operate a scrub wand.
To start pump, press the switch.
To stop pump, press the switch.
ADJUSTMENT LEVER
The height of the control panel and tower are
adjustable.
To adjust control panel height, pull up on
height adjustment lever, move control panel
up or down to desired height, then release the
lever to lock the control panel in position.
Controls the machine direction, and scrub
brushes and solution flow.
To propel machine forward, push the lever
forward.
To propel machine backward, pull the lever
toward you.
The scrub brushes will not rotate and the
solution will not flow to scrub deck with the
directional control lever in neutral (except at
initial brush start-up, when it will run briefly
then stop if lever is in neutral).
Shuts off machine.
To shut off machine, push the switch.
To restart machine, rotate the switch
clockwise.
Records the number of hours the machine has
been in operation. This information is useful
in determining when to service the machine.