10/100Mbps Unmanaged Switch
Chapter 4 Connection
4.1
Ethernet Port
Connect a Ethernet port of the switch to the computer by RJ45 cable as the following
figure shows.
Figure 4-1
4.2
Verify Installation
After completing the installation, please verify the following items:
There are 5 to 10cm of clearance around the sides of the device for ventilation and the
■
air flow is adequate.
The voltage of the power supply meets the requirement of the input voltage of the device.
■
The power socket, device and rack are well grounded.
■
The device is correctly connected to other network devices.
■
4.3
Power On
Plug in the negative connector of the provided power cord into the power socket of the
device, and the positive connector into a power outlet as the following figure shows.
Figure 4-2
16
Connection
Connecting the RJ45 Port
RJ45 Port
Connecting to Power Supply
RJ45 Cable