TP-Link TL-SF1016DS Installation Manual page 7

LEDs
LED Status
On
Power Off
Flashing
On
Flashing
Link/Act
Off
On
100Mbps
Off
Note:
Because of the difference among the switch models, some switches don't have
the 100Mbps indicator, such as TL-SF1048, TL-SF1016DS and TL-SF1024D
switch.
10/100Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps. Each
has a corresponding 10/100Mbps LED.
Rear Panel
■
The rear panel of the switch is shown as the following figure.
Figure 1-6 Rear Panel
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground
the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 3 Lightning Protection.
Indication
The switch is powered on
The switch is powered off or power supply is
abnormal
Power supply is abnormal
A device is linked to the corresponding port
Data is being transmitted or received
There is no device linked to the corresponding
port
The corresponding port is running at 100Mbps
There is no device linked to the corresponding
port or the port is running at 10Mbps
10/100Mbps Unmanaged Switch
Grounding Power
Terminal Socket
Introduction 03