Advanced Operations; Call 1/Call 2; Monitor; Momentary Monitor - AnyTone AT-289 Instruction Manual

ADVANCED OPERATIONS

The [PF1] and [PF2] keys are programmable. They can realize the following functions by
programming software.
NOTE: When programming the following functions as [PF1] 1S key or [PF2] 1S key, you need to press
the [PF1] / [PF2] key for one second till the transceiver beeps and then release the key to realize the
programmed function.

Call 1/Call 2

Under the standby conditions, press the programmed key of Call1/Call2 ( [PF1]/[PF2] ) to transmit
the prestored and selected DTMF signaling.

Monitor

Under the standby conditions, pressing the programmed key of monitor [PF1] / [PF2], the
transceiver emits "DU" beep and then comes into the monitor state. Under these conditions,
transceiver will ignore CTCSS / DCS decode and monitor signal of the other party as long as
receiving the matched carrier wave. Press this key again, transceiver emits "DU DU" beep and exits
the monitor state.

Momentary Monitor

Under the standby conditions, press and hold the programmed key of momentary monitor [PF1]/
17
Professional
FM Transceiver