Set Up Audio - Axis C1004-E User Manual

AXIS C1004-E Network Cabinet Speaker
Audio
How to set the volume for speakers in a zone
Go to Audio > Audio Overview.
These settings are available when the speaker is connected to at least one more speaker.
1. Use the slider System under Volume to set system volume for max announcement sound level
2. Set volume in Axis Audio Player for the background music sound level.
3. If needed use the sliders beside the followers to adjust the balance between speakers by decreasing the individual volume
for the louder speakers and repeat step 1 and 2.
How to identify speakers in a zone
Go to Audio > Audio Overview.
Identify all speakers in the zone - Click on the upper note and all speakers that are connected to the speaker system will make a
sound.
Identify a single speaker in the zone - Click on the note beside a follower and that speaker will make a sound.

Set Up Audio

To set up the Axis product, go to Audio > Audio Settings.
Auto Speaker Test
The Auto Speaker Test is a test that can be initiated from a remote location to verify that the speaker is working as intended. The
speaker plays a series of test tones that are measured by the built-in microphone. The registered test tones are saved as reference
values to optimize speaker performance to its specific surroundings at the installation site.
The Auto Speaker Test must be calibrated during first time use from its mounted position at the installation site. If the speaker is
moved or if its local surroundings change, for example, if a wall is built or removed, the speaker should be re-calibrated.
Note
During calibration, it is recommended that someone is physically present at the installation site to listen to the test tones and
ensure that the test tones are not muffled or blocked by any unintended obstructions in the speaker's acoustic path.
To calibrate the Axis product and run an Auto Speaker Test, follow the instructions below:
1. Go to Setup > Audio > Audio Settings.
2. Click Calibrate to calibrate Axis product and run the first Auto Speaker Test.
It is also possible to run the Auto Speaker Test by pressing the control button. See Product overview.
Once the Axis product is calibrated, the Auto Speaker Test can be run at any time:
1. Go to Setup > Audio > Audio Settings.
2. Click Test to run the Auto Speaker Test.
To set up the Auto Speaker Test as an action rule, see How to set up action rules on page 22.
Audio Modes
The Axis product supports the following audio modes:
• Full duplex – Simultaneous two-way audio allowing the Axis product to transmit and receive audio at the same time.
There is no echo cancellation; if feedback loops appear, try moving the microphone or the speaker.
11