Ports & Devices; Maintenance - Axis C1004-E User Manual

AXIS C1004-E Network Cabinet Speaker
About system options
Traps for SNMP v1/v2 are used by the Axis product to send messages to a management system on important events and status
changes. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community that
should receive the message.
The following traps are available:
• Cold start
• Warm start
• Link up
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS on page 27. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see How
to reset to factory default settings on page 35.
UPnP
The Axis product includes support for UPnP
systems and clients that support this protocol.
UPnP can be disabled under System Options > Network > UPnP.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.
Ports & Devices
LED Settings
The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports &
Devices > LED.
The available options for the Status Indicator LED are:
• Normal: The status LED shows steady green during normal operation. This is the default setting.
• Off: The status LED is off during normal operation. This can be useful in making the Axis product less noticeable.

Maintenance

The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Note
A restart clears all entries in the Server Report.
®
. UPnP is enabled by default and the product is automatically detected by operating
33