Table of Contents
Advertisement
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the fuel
system, use fuel stabilizer at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around fuel tank cap and remove the cap.
Add unleaded regular gasoline to fuel tank, until the
level is 1/4 to 1/2 inch (6 to 13 mm) below the
bottom of the filler neck. This space in the tank
allows gasoline to expand. Do not fill the fuel tank
completely full.
3. Install fuel tank cap securely. Wipe up any gasoline
that may have spilled.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
Oil Level in Engine Maintenance.
Note: Determine the left and right sides of the
machine from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals in
the safety section. Knowing this information could
help you or any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
CAUTION
This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
Operating the Parking Brake
Always set the parking brake when you stop the
machine or leave it unattended. Before each use, check
the parking brake for proper operation.
If the parking brake does not hold securely, adjust it.
Refer to Servicing the Parking Brake.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it
is unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Setting the Parking Brake
Pull the parking brake lever rearward (Figure 7).
1. Parking brake lever (in the
released position)
Releasing the Parking Brake
Push the parking brake lever forward.
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Set the parking brake.
4. Move the throttle control to fast and move the
choke lever to the on position before starting a cold
engine (Figure 8).
Note: A warm or hot engine may not require
choking. To start a warm engine, move throttle
control midway between the fast and slow
positions.
14
Figure 7
2. Parking brake lever (in the
engaged position)
Advertisement
Table of Contents
