Set Up; Loose Parts; Installing The Control Panel And Fuel Tank - Toro 30332 Operator's Manual

Set Up

Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Fuel tank
Control panel
Bolt, 5/16 x 7/8 in. (22.5 mm)
Lock washer, 5/16 in.
Washer, 5/16
Spring
Stud
Hose clamp
Shift lever
Rubber seal
Square hole washer
Spring washer
Locknut, 3/8 in.
Upper handle
Flanged bolt, 3/8 x 1 in. (26 mm)
Flange nut, 3/8 in.
Clevis pin
Washer
Hairpin cotter pin
Hairpin cotter pin
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card
Installing the Control Panel
and Fuel Tank
Note: Hardware to install control panel and fuel tank is
installed in the bottom of fuel tank.
QTY.
1
1
2
2
Install fuel tank and control panel
4
2
2
1
1
1
1 Install shift lever
1
1
1
4 Install upper handle to frame
4
2
2 Install control rods
2
2 Install hairpin cotter pins
1 Read before operating machine
1 Read before operating machine
1
1 Fill out and return to Toro
1. Remove the bolts and nuts holding the control panel to
the rear frame. Discard these nuts and bolts.
2. Slide the control panel under the bottom of the rear
frame (Fig. 2).
13
USE