Table of Contents
Advertisement
to connect to the wisenet DDnS in camera setup
1. From the DDNS setup page, set <DDnS> to <wisenet
DDnS>.
2. Provide the <product iD> that you registered product ID with
the DDNS site.
3. Click [apply].
When the connection is successfully made, you will see the
message of <(Success)> on the screen.
configuring public DDnS in camera Settings
1. Open the DDNS settings page and select <public DDnS> for <DDnS>.
2. Enter the corresponding site's host name, user name and password.
3. Click [apply] button.
If the connection properly establishes, <(Success)> appears.
4. When done, click [apply].
To use DDNS service properly, both DDNS setup and the router's port forwarding setup are required.
`
M
For port forwarding setup, refer to "Port Range Forward (Port Mapping) Setup". (page 18)
ip filtering
You can create a list of IPs that you want to grant or deny access to them.
1. From the Setup menu, select the <network (
2. Click <ip filtering>.
3. Select <filtering type>.
• Deny registered IP : If selecting this, access from those IPs
that are added to the filtering will be restricted.
• Allow registered IP : If selecting this, access from only
those IPs that are added to the filtering will be accepted.
4. Click the [add] button.
The IP list will be created.
5. Provide the IP that you want to grant or deny access from.
When you enter an IP address and a Prefix, the list of IP addresses available will appear in the right-side
filter range column.
)> tab.
If selected <Allow registered IP> for IP Filtering and <IPv6 setup> of <IP & Port> is set to <Use>, both IPv4 and IPv6
`
M
addresses of the computer currently configuring should be assigned.
The IP address of the computer used for the current setup cannot be added to <Deny registered IP>, it should be added to
`
<Allow registered IP>.
Only the IP addresses that are set to <Use> will be displayed in the filter column.
`
6. Select an IP to delete from the list.
Click the [Delete] button.
7. When done, click [apply].
HttpS
You can select a secure connection system or install the public certificate for this purpose.
1. From the Setup menu, select the <network (
2. Click <HttpS>.
3. Select a secure connection system.
To access the camera using HTTPS mode, you have to type the IP
`
address for the camera in the form of "https://<Camera_IP>".
If you failed to configure the Web viewer settings in HTTPS mode with
Internet Explorer, edit the Internet options as follows: <Menu Tools
Internet Options Advanced Security Uncheck TLS 1.0, and check
TLS 1.1, TLS 1.2>
4. Search for the public certificate that you want to install on the camera.
To install the certificate on the camera, you need to provide a certificate name (it can be arbitrarily assigned
by the user), certificate file issued from the certification authority and a key file.
The <HTTPS (Secure connection mode using the public certificate)> item will be active only if there exists a public certificate
`
installed.
5. When done, click [apply].
installing the certificate
1. Enter the certificate name.
2. Click the [Browse (
)] button, select the public certificate file and key file to be installed, and then click
the [install] button.
Deleting the certificate
1. Click [Delete] button.
2. To delete a public certificate, you should access the network video decoder in the mode of <Http (Do
not use secure connection)> or <HttpS (Secure connection mode using a unique certificate)>.
)> tab.
English _39
Advertisement
Table of Contents
