Setup; Basic Setup - Samsung XNO-6080R User Manual

setup screen

Setup

You can configure the basic camera information, PTZ, video and audio, network, event, analyze and system
settings.
1. On the live screen, click the [Setup (
2. The Setup screen appears.

BaSic Setup

video profile
1. From the Setup menu, select the <Basic (
2. Click <video profile>.
3. Set the <video profile connection policy>.
• Keep connection when profile setting is changed : Output
uses the same settings even when the settings of the
active profile are changed.
If not selected, changing a profile used by an existing
connection resets such connection.
Select each profile properties.
For more details, refer to "to add/change the video
profile". (Page 28)
4. Click the input box of each item and enter / select a desired
value.
The context menu may differ depending on the selected codec type.
`
• Default profile : If no profile is selected when using the Web
Viewer, the default video profile is applied.
• E-mail/FTP profile : Video profile to be transferred to the specified email or FTP site.
Only the MJPEG codec can be set as the E-mail/FTP profile.
`
• Record profile : This is the profile that is applied to video recording.
• DPTZ Profile : Profile applied when using the PTZ.
To use PTZ, add a DPTZ profile.
`
5. Select whether or not to input audio in the video.
Select the <audio in> check box and you can input audio in the video.
)] button.
)> tab.
6. According to your situation, set ATC (Auto Transmit Control) mode.
• ATC mode : It adjusts the video properties according to the
variance in the network bandwidth, controlling the bit rate.
Adjusting the bit rate depends on the ATC mode.
- Control framerate : Reduce the frame rate if the network
bandwidth drops down.
- Control compression : Control the compression rate if the network bandwidth drops down.
Compression adjustment can cause deterioration of the image quality.
- Event(MD) : Activated when the motion detection (MD) event is set. Frame rate is adjusted when an
event occurs.
If no motion is detected in the surrounding area, the minimum amount of frames is output to save the
bandwidth use.
If <Bitrate control> is set to <CBR>, the encoding priority according to the ATC mode will be fixed as below:
`
Bitrate control / ATC mode Control framerate
CBR Compression
• Sensitivity : Affect the transfer rate according to the variance in the network bandwidth.
The transfer rate will be adjusted to the fastest if the bandwidth is <very high>, and adjusted to the
latest if the bandwidth is <very low>.
• Limit : If the quality or frame rate is adjusted, the property will be changed to the applied value (%)
against the previous setting value (100%).
Note that if you reduce the property value too much, you may encounter flickering on the screen. So it
is advisable to adjust the value within the threshold.
It is recommended to apply ATC control only for cameras supporting ATC.
`
J
Set the ATC sensitivity to <Very low> in a network environment with high variance in the network bandwidth.
`
If the network connection is unstable, you may encounter flickering on the screen.
`
7. Select Able or Disable for the Crop Encoding function.
For more details, refer to "to use crop encoding". (Page 29)
• Crop encoding : It cuts only the selected area out of the full screen and outputs it at the resolution
specified in <profile setting>.
The resolution should be less than the Crop Encoding setting area.
8. When done, click [apply].
Control compression Event(MD)
Framerate Framerate
English _27