Dynamic Ip Setup; Port Range Forward (Port Mapping) Setup - Samsung XNO-6080R User Manual

network connection and setup

Dynamic ip Setup

Dynamic ip environment Setup
• Example of the Dynamic IP environment
- If a Broadband Router, with cameras connected, is assigned an IP address by the DHCP server
- If connecting the camera directly to modem using the DHCP protocols
- If IPs are assigned by the internal DHCP server via the LAN
checking the Dynamic ip
1. Run the IP Installer on the user's local computer.
Cameras allocated with <Dynamic ip> address are shown in
the list.
2. Select a camera from the search result.
3. Click the [manual Set] button and check the camera's
<Dynamic ip> address.
If you uncheck <DHcp>, you can change IP to <Static>.

port ranGe forwarD (port mappinG) Setup

If you have installed a Broadband Router with a camera connected, you must set the port range forwarding on the
Broadband Router so that a remote PC can access the camera in it.
manual port range forwarding
1. From the Setup menu of the Broadband Router, select
<applications & Gaming> - <port range forward>.
For setting the port range forward for a third-party Broadband
Router, refer to the user guide of that Broadband Router.
2. Select <tcp> and <uDp port> for each connected camera
to the Broadband Router.
The number of each port to be configured to the IP router
should be set according to the port number designated
in <Setup> - <Basic> - <ip & port> on the camera web
viewer.
18_ network connection and setup
3. When done, click [Save Settings].
Your settings will be saved.
Above sample instructions are based on the CISCO's Broadband Router.
`
M
The settings may differ depending on the connected Broadband Router model.
`
For more information, refer to the user manual of the applicable router.
Setting up port range forward for several network cameras
• You can set a rule of Port Forwarding on the Broadband Router device through its configuration web page.
• A user can change each port using the camera setting screen.
When Camera1 and Camera2 are connected to a router :

User Internet

Broadband Router
Start End Protocol IP Address
3000 3000 TCP/UDP 192.168.1.100
3001 3001 TCP/UDP 192.168.1.101
4520 4520 TCP/UDP 192.168.1.100
4521 4521 TCP/UDP 192.168.1.101
8080 8080 TCP/UDP 192.168.1.100
8081 8081 TCP/UDP 192.168.1.101
Port forwarding can be done without additional router setup if the router supports the UPnP (Universal Plug and Play) function.
`
M
After connecting the network camera, select the checkbox from the menu <Quick connect> in <Wisenet DDNS> in
"Settings -> Network -> DDNS".
Camera1 (192.168.1.100)
HTTP port 8080

Device port 4520
RTSP port 3000
Camera2 (192.168.1.101)
HTTP port 8081

Device port 4521
RTSP port 3001