Samsung XNO-6080R User Manual page 30

setup screen
• Current users : If you select <use>, you can set or change the user permissions.
The administrator can set the audio input, audio output, alarm output permissions.
`
Audio input/Audio output/Alarm output : You can enable/disable Audio input/Audio output/Alarm output in the live mode on the
`
current user account.
Profile : If you select <Default>, you can only see the default profile video; if selecting <All>, you can see the full profile
`
videos.
ONVIF functions available to a registered user allowed to use ONVIF functions are limited to those of granted with permission.
`
J
4. When done, click [apply].
Date & time
1. From the Setup menu, select the <Basic (
2. Click <Date & time>.
3. Specify the time and date that will be applied to the camera.
• Current system time : Displays the current time settings of
your system.
• Timezone : Specify the local time zone based on the GMT.
• Daylight saving time : If checked, the time will be set one
hour before the local time zone for the specified time
period.
This option will be displayed only in areas where DST is applied.
• System time setup : Specify the time and date that will be applied to your system.
- Manual : Sets the current time of the camera manually.
When you select the <Synchronize with pc viewer> check box, the time of the webviewer is set to
the time displayed on the PC that runs the webviewer.
- Synchronize with NTP server : Sync with the time of the specified server address.
4. When done, click [apply].
If you select the <Synchronize with PC viewer>, the standard timezone should be set the same as the current timezone in
`
J
PC.
30_ setup screen
)> tab.
ip & port
1. From the Setup menu, select the <Basic (
2. Click <ip & port>.
3. Click <ip address>.
4. Set the <ipv4 setup>.
• IP type : Select an IP connection type.
- Manual : Specify the IP address, Subnet mask,
Gateway, DNS1, and DNS2.
- DHCP : Specify the DNS1 and DNS2.
- PPPoE : Specify the DNS1, DNS2, ID and Password.
If you set it to <Manual>, you should specify the IP, Subnet mask, Gateway, DNS 1 & 2 manually.
`
• MAC address : Shows the MAC address.
• IP address : Displays the current IP address.
• Subnet mask : Displays the <Subnet mask> for the set IP.
• Gateway : Displays the <Gateway> for the set IP.
• DNS1/DNS2 : Displays the DNS(Domain Name Service) server address.
5. Set the <ipv6 setup>.
Set to <Use> to use IPv6 address.
`
• Default : Use the default IPv6 address.
• DHCP : Display and use the IPv6 address obtained from the DHCP server.
• Manual : Enter IP address and gateway manually and use it.
The IP addressing system will be defaulted to DHCP. If no DHCP server is found, the previous settings will be restored
`
J
automatically.
Once completed with editing, click [Apply] to apply changes and the browser exits. After a while, connect again with the
`
changed IP.
)> tab.