RED COMPACT 14-2015 Installation Manual page 40

Pellet boiler
Table of Contents

Advertisement

9 - FIRST START-UP
Do not stand close to the stove and, as mentioned, air the room. The smoke and smell of paint will disappear after about an hour of
operation, however, they are not harmful in any case.
The boiler will be subject to expansion and contraction during the lighting and cooling down stages, and may therefore make slight
creaking noises.
This is absolutely normal as the structure is made of laminated steel and must not be considered a defect.
It is extremely important to make sure the boiler does not reach high temperatures straight away, but to increase the temperature
gradually using low power at first.
This will prevent damaging the ceramic or serpentine stone tiles, the welds and the steel structure.
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
ATTENTION!
If during operation or initial ignition you encounter smoke spillage in to the room from the appliance
or the flue then please switch off the appliance, ventilate the room and contact the installation / service
engineer immediately.
SETTINGS TO BE CARRIED OUT BEFORE THE INITIAL START-UP
I
After connecting the power cable to the electrical socket, turn the power switch to the (I) position. Turn the boiler on or off at button 1
on the control panel.
38
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents