Interface Menu; Job Timeout; Ethernet - Konica Minolta bizhub 40P Service Manual

9. Menu
9.7

INTERFACE MENU

9.7.1

JOB TIMEOUT

Function • Sets the time to activate JOB TIMEOUT.
Use • To specify the amount of time before a print job times out.
Setting • The default setting is 15 seconds.
/procedure
9.7.2

ETHERNET

NOTE
• When the ETHERNET setting is changed, the printer restarts automatically.
A. TCP/IP
(1) ENABLE
Function • Enables TCP/IP.
• To specify that the printer is connected to a TCP/IP network.
Use YES : Enable TCP/IP. Print can be made at TCP/IP environment.
NO : Disable TCP/IP. Print cannot be made at TCP/IP environment.
Setting • The default setting is YES.
/procedure
NOTE
• The folowing screen displays only when [ENABLE/YES] is selected.
IP ADDRESS/SUBNET MASK/DEFAULT GATEWAY/DHCP/BOOTP/ARP/PING/
HTTP/FTPTELNET/BONJOUR/DYNAMIC DNS/IPP/RAW PORT/SLP/SMTP/
SNMP/WSD PRINT/IPSEC/IP ADDRESS FILTER/IPv6
(2) IP ADDRESS
Function • Sets the IP address of the printer used for the network.
Use • To set the printer's IP address.
Setting 1. Select [IP ADDRESS] and press the Menu/Select key.
/procedure 2. Set desired IP address (first bite) with the up key /down key
key .
3. Repeat the above procedures and set the IP address up to fourth bite.
4. Press the Menu/Select key.
NOTE
• When setting the IP address manually, [DHCP], [BOOTP] and [ARP/PING] set-
tings are set to [OFF] automatically.
• When IP address is not allocated from the server, the IP address is set auto-
matically within the range "169.254.0.0. to 169.254.255.255."
106
5 seconds to 300 seconds
"YES"
Field Service Ver. 1.0 Dec. 2007
NO
and press the right