Table of Contents
Advertisement
Time display
The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
Symbols appear to indicate which
stage the programme is at:
Pre-wash
1
Main wash
8
Interim rinse
%
Final rinse
(
Drying
G
Finished
O
The time displayed may vary with the
same programme. This can be due
among other factors, to the water
temperature at each intake, the
reactivation process and the amount of
crockery.
When a programme is selected for the
first time, the display shows an average
duration. This will vary once the
machine has been used.
Programme durations will vary for other
electrical variants.
Standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The display and the
indicator lights will go out and only the
Start/Stop indicator will flash slowly.
^ Press any button to switch the
display and indicator lights back on
again.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode (see "Settings menu,
Optimise standby").
The dishwasher will not switch into
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be replenished or there is a fault.
You can switch off the reminders to
replenish salt and rinse aid so that
the dishwasher will go into Standby
despite a lack of salt or rinse aid
(see "Settings menu, Refill display").
You cannot switch off fault
messages.
Operation
35
Advertisement
Table of Contents
