Table of Contents
Advertisement
Delay start
The start time of a programme can be
delayed, e.g. to benefit from economy
rates of electricity. A delay start time of
between 30 minutes and 24 hours can
be selected. The delay start time is set
in 30 minute steps.
When using the Delay start function,
make sure that the detergent
compartment is dry before adding
detergent. Wipe dry with a cloth if
necessary. If the compartment is
wet, powder detergent can become
lumpy and stick to the dispenser,
with the result that it is not fully
dispensed.
^ Switch the dishwasher on with the -
button.
The Start/Stop indicator light will flash.
^ Select the programme you require
(see "Operation, Selecting a
programme").
^ Press the , button.
The last delay start time used will
appear in the display. The Delay start
indicator light will come on.
^ Set the required time using the ,
button.
If the button is kept pressed in, the time
will increase automatically up to
24:00 h
. To start at 30 minutes again,
press the , button twice.
Additional functions
^ Press the Start/Stop button.
The Start/Stop indicator light will light
up constantly.
If, after you have set the delay start
time, you do not press the Start/Stop
button within a few seconds, the
display will revert to showing the
programme duration. You will have to
enter the delay start time again.
The delay start time then counts down
to the start time selected in minute
stages.
At the end of the delay period, the
programme selected begins
automatically. The time left for the
programme to run then shows in the
display, the Delay start indicator light
will go out and the Start/Stop indicator
light will light up constantly.
,
To prevent children coming into
contact with dishwasher detergent,
do not fill the detergent dispenser
until just before starting the
programme, i.e. before pressing the
Start/Stop button, and activate the
safety lock.
39
Advertisement
Table of Contents
