Leica Rugby 820 User Manual page 37

Adjusting the Y-axis
step-by-step
Exiting adjustment
mode step-by-step

Rugby 820/830, Accuracy Adjustment
Step Description
1. Press the Up and Down Arrow buttons to increment the laser beam up and
down. Each increment is indicated by a flash of the Y-axis LED and a beep
from the audio indicator.
2. Continue to press the Up and Down Arrow buttons and monitor the spot
until the Rugby is within its specified range.

Five steps are equal to 10 arc seconds of change, or approximately
1.5 mm at 30 m (1/16" at 100').
3. Press the Automatic/Manual Mode button to switch back to the X-axis if
desired.
Press and hold the Automatic/Manual Mode button for 3 seconds to save and exit
Adjustment Mode.
The X-axis LED and Y-axis LED flash alternately three times, then the Rugby shuts off.
Pressing the Power button at any time while in Adjustment Mode will exit the mode
without saving changes.
37