Advertisement

Dishwasher
DW12-CBE7
Instructions for Use
Code: 012050

Advertisement

Table of Contents
loading

Summary of Contents for Eurolux DW12-CBE7

  • Page 1 Dishwasher DW12-CBE7 Instructions for Use Code: 012050...
  • Page 2: Table Of Contents

    Index Safety information Installation Getting to know your dishwasher How to fill the salt How to fill rinse aid How to fill the detergent Not suitable for the dishwasher Arranging crockery, glasses, etc. in the dishwasher Programme overview Washing dishes How to keep your dishwasher in shape Care and maintenance Fault finding...
  • Page 3: Safety Information

    Safety information At time of delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly. During installation Place the dishwasher and connect it up in accordance with the installation instructions.
  • Page 4 If your family includes children This appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capcabilities, or lack of experience and knowledge,unless they have been given supervi- sion or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they to not play with the appliance.
  • Page 5: Installation

    Installation Positioning the appliance Change the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. Levelling the appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level.
  • Page 6 Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose (fig.B).
  • Page 7 Installation cont.. Stage 1 Supplied with the appliance is a plastic (self adhesive) anticondensation strip, this should be fixed to the underside of your worktop along the front edge. The adjustable feet of the ap- pliance allow it to be raised up to 870mm, if the space between the floor and the underside of the work surface is greater than fig 1a 870mm, then the appliance should be positioned on suitable...
  • Page 8 Stage 5 Align the top of the decor door with adjacent cabinets. Gently open door whilst supporting the decor door. Once in the lowered position, secure the decor door using the fixing screws provided as shown in the diagram. Cover the screw heads using the plas- tic caps provided.
  • Page 9 Assembly Instructions for Integrated Dishwasher Mounting the Wooden Panel onto the Door and Sliding the Dishwasher into the Cabinet During the preparatory stages for installing the dishwasher into the kitchen cabinet, holes must not be drilled in the sides, or door, in order to avoid compromising the performance and/or operation of the appliance.
  • Page 10 Insert the top hooks into the appropriate slots in the dishwasher control panel. Then push the panel upwards until it stops. After- wards , slide the panel downward again, moving the bottom of the panel toward the door so that the fins on the brackets slide into their slots (see Fig.3).
  • Page 11 How to use water-proof plastic Firstly take off the water-proof plastic from the sticker with the ap- pliance (see I, Fig.8). Secondly stick it on the bottom of the kitchen board (see II, Fig.8). All of this can avoid humidity in the kitchen.
  • Page 12: Getting To Know Your Dishwasher

    Getting to know your dishwasher Close-up view (control panel) Programme Indicator Time-remaining Indicator Programme Button Delayed Start Button "3 in 1" Button " 1/2 " Button Low Rinse Aid Indicator ON-OFF Button Low Salt Indicator ON-OFF Indicator Dishwasher interior Upper Rack Salt Container Cap Lower Rack Washing Filter...
  • Page 13: How To Fill The Salt

    How to fill the salt Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
  • Page 14: How To Fill Rinse Aid

    How to fill rinse aid Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . When the low rinse aid indicator “ D ” lights , you must load rinse aid . Loading the rinse aid Regardless of the type of detergent dispenser installed on your appliance, you must proceed as indicated below when loading the rinse...
  • Page 15: Not Suitable For The Dishwasher

    Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Delicate decorative glassware and vases,special antique or irreplaceable china.
  • Page 16: Arranging Crockery, Glasses, Etc. In The Dishwasher

    Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher,re- move larger food particles to prevent the filter from b e c o m i n g c l o g g e d , r e s u l t i n g i n r e d u c e d performance.
  • Page 17 The lower rack features fold down tine rows (see fig.I) so that larger or more pots and pans can be loaded. Using the upper rack The upper rack is designed to hold more delicate and lighter dishware,such as glasses,cups and saucers,plates,small bowls and shallow pans (as long as they are not too dirty).
  • Page 18: Programme Overview

    Programme overview Type of Condi- Type of Amount of crokery e.g. Wash tion of china, pots/ food food Description of cycle 3 in 1 pan s, food programme Load remains remains cutiery, remains glasses, etc Pre-wash with hot water. Extended wash at 70°C. Soups, Rinses with cold water.
  • Page 19 Detergent Delayed Energy Water Duration in Rinse Aid Start consump- consump- Extended minutes Prewash tion in kWh tion in litres Wash 1.44 1.25 1.11 1.00 1.05 0.95 1.01 0.95 0.40 0.30 0.90 0.78 0.02 0.02 *EN50242 test with rinse aid setting 5...
  • Page 20: Washing Dishes

    Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are shown in the right half of the overview.
  • Page 21 Switching the dishwasher ON Turn on the tap. Open the door. Set ON-OFF button “I” to ON. Press programme button “B” , programme indicator “ A” lights and the time-remaining indicator “ ” dis- plays the time of the programme.. If the door is closed, the programme indicator “A”...
  • Page 22 Delayed start programming You can delay the start of a programme in increments of 1 hour up to 24 hours. Switch dishwasher Immediately press the Delayed Start button “ G ”, the delayed start indicator lights, the delayed start time indicator “ ”...
  • Page 23 3in1 function When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may be helpful therefore to switch the rinse aid off (please note that only some dishwashers have this facility) and selecting the lowest possible setting for water hardness. If you decide to switch to the use of a standard detergent system we advise that you: 1: Refill both the salt and rinse aid compartments.
  • Page 24 Tabs With Classic Tabs you can put your dirtiest dishes straight into the dishwasher. The tab contains StainSoakers which dissolve instantly to soften really dried on food residues such as baked on egg and cheese sauces. The blue layer then works to break down and lift off food remains while the white layer cleans all traces of dirt away for a spotless and brilliant finish.
  • Page 25: How To Keep Your Dishwasher In Shape

    How to keep your dishwasher in shape After Every Wash After every wash, set the main switch “I” to off and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. No solvents or Abrasive Cleaning Products To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.
  • Page 26: Care And Maintenance

    Care and maintenance Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance Check that no grease or scale has accumulated on the inside of the dishwasher. If you discover any deposits: Clean the interior of the dishwasher thorughly with a detergent solution.
  • Page 27: Fault Finding

    Fault finding Resolving minor problems yourself Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner.
  • Page 28 When “ ” (F) blinks. Have you checked whether: the drain hose is crimped or bent. the drain hose is too high. When “ ” (F) blinks. Have you checked whether: the water is turned on and the hose is connected properly; the water supply to the house is on and has sufficient pressure;...
  • Page 29 Water remains inside appliance after programme has ended Blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end ..during washing Unusual amount of foam is creased Normal washing up liquid has been poured into the rinse-aid container.
  • Page 30 Plastic items are discoloured Not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. White stains are left on crockery, glasses have a milky appearance Not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low.
  • Page 31: Technical Data

    Technical data 59.6 cm Width Depth 55 cm Height 82 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6MPa Power voltage 220-240V~ 50Hz Maximum current intensity 2150W Total absorbed power Important information Notes on waste disposal Old appliances still have some residual value. An environment-friendly method of disposal will ensure that valuable raw materials can be recovered and used again.
  • Page 32 Information on comparability tests implemented in compliance with EN 50242 Appliance loaded in a ccordance w ith standard specifications. Example of loaded dishwasher: See Fig 1, 2 and 3. Capacity: 12 place settings Comparability programme: Light wash Rinse-aid setting: 5 Detergent: 5g+25g Fig.1 Fig.2...
  • Page 33 Circuit Diagram WB: Wiring box SV: Softener valve HR: Heating element relay DS: Door switch OS: Overflow switch SSS: Spy salt switch WS: Water level switch IV: Inlet valve SRS: Spy rinse aid switch DP: Drain pump WP: Washing pump TS: Temperature sensor DV: Dispenser valve TL: Temperature limiter...

Table of Contents