Table of Contents
Advertisement
Thank you for choosing the Orchid Telecom KS832 telephone system. Please take time to read
through this Administration guide to get the most from your new purchase.
Please note: This system is expandable up to a KS1664 which would give you 16 lines with 64
extensions. Please see page x for further details and installation of the additional circuits.
• Ensure the On/Off switch, located on the left hand side of the Key System is switched to
On. (-)
• All extension sockets should be Master type with built in ringing capacitor. (If you use a
secondary type socket, and your extension phones are older type 4-wire working, they may
not ring).
• We have a range of "Easy Install" adaptors for connecting the extensions. They are
available in 4 lengths; 10cm, 5m,10m and 20m ,Please contact your supplier for more
details.
• Only extensions 201-204 will ring on incoming calls (factory default setting) unless you
nominate any other extensions to ring. See page 7 of the Administration Guide.
• The extension sockets inside the system are numbered 01 to 64. 01 Being the socket for
extension 201 and 64 being the socket for extension 264, should you expand the system to
the maximum capacity.
Wall Mounting:
• Drill 2 holes, 25.2cm apart. and a third one 26cm below and central to the 2 above. (Take
extra care not to drill through electrical wiring or pipes.)
• Adjust the screw heads until the KS fits firmly against the wall.
Introduction
Installation Hints
4
Advertisement
Table of Contents
