Paramount Fitness FL-33 Assembly Manual page 14

The FL-33 Hardware Box is packed with a weight stack number label set. Follow the instruc-
tions printed on the label. Below is a list of weight stacks and the corresponding label set part
numbers:
To install weight stack labels:
1. Verify weights are installed properly.
2. Wipe front surface of the weights with rubbing alcohol and allow to dry completely.
3. Remove the backing from the labels. Align the top edge of the label with the top edge of
the weights and the side of the label with the outside edge of the pin hole in the weights.
4. Verify that the label strip is straight and then remove the liner. As the liner comes off the
labels, press and rub each label into place.
5. The adhesive requires 48 hours to cure so DO NOT attempt to "test" the integrity of the
labels after they have been installed.
Take the time during installation to align the label with the edge of the pin hole and the top
surface of the weights to get all of the individual labels straight.
Individual
labels
Align with outside
edge of pin holes
F
ITNESS
WEIGHT STACK LABELS
Wt. Stack 170lb
Part No. B2170
L
INE
250lb
B2172
Liner
13