Table of Contents
Advertisement
asphalt, tile or other similar hard materials.
Set the variable clutch to the "Drill" symbol. Turn
the hammer or drill control to the "Hammer"
symbol for impact drilling.
8. DRILLING
When drilling hard smooth surfaces, use a center
punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the
hole is started. Hold the tool firmly and place the
tip of the bit at the point to be drilled. Depress
the switch trigger to start the tool. Move the drill
bit into the work-piece, applying only enough
pressure to keep the bit drilling. Do not force or
apply side pressure to elongate a hole.
WARNING: Tungsten carbide drill bits
should always be used for concrete
and masonry. When drilling in metal, only
use HSS drill bits in good condition. Always
use a magnetic bit holder when using short
screwdriver bits. When screw-driving, apply
a small quantity of liquid soap or similar to
the screw threads to ease insertion.
9. USING THE LED WORK LIGHT (See Fig J)
The LED work light allows you to keep a clear view
under less illuminated circumstances. To turn on
the light simply press the on/off switch. When you
release the on/off switch, the light will be off.
CAUTION The light is a focussed beam and
should never be pointed directly into the eyes of
people or animal.
10. MAGNETIC TRAY (See Fig K)
The bits/screws provided with the drill can be
placed on the magnetic tray during working for
convenience.
11. BATTERY CAPACITY INDICATOR (See
Fig L)
The indicator (5) is located on top back of the
drill. Press the button (6) to show the current
battery capacity.
Better to charge the battery when the capacity is
less than 20%.
COMBI DRILL
TTD129COM & TTE130COM
Fig J
Fig K
5
6
Fig L
Advertisement
Table of Contents
