Crestron TPS-XVGA-BV Operations & Installation Manual page 16

RGB Computer Interface Card for TPS/Tilt Panel
13. Position the touchpanel base cover onto the base.
14. Hold the touchpanel base cover in place and position the
15. Re-install the eight base cover screws to finger-tight then,
NOTE: The TPS-IMC, optional TPS-IMW, and TPS-IMC-BV serve as
an interface between the touchpanel and the video source computer
and/or the Cresnet system. If the touchpanel is equipped with optional
TPS-VID Video Card, the audio and video cables from the TPS-IMC to
the touchpanel are replaced with the triamese cable. The TPS-IMC must
be replaced by the TPS-IMC-BV. For further information, consult the
TPS-IMC-BV Operations Guide (Doc. 5921). The latest revision can be
obtained from the Products page (PRODUCT MANUALS section) or
Downloads page (MANUAL Library) of Crestron's website
(www.crestron.com). New users are required to register to obtain access
to the FTP site.
16. Refer to the diagram below. At the rear of the touchpanel base,
Installation Diagram 7 of 7 - Attach Triamese Cable Connectors
17. Re-connect any cables that were disconnected in step 2 to the
18. If the optional external power pack is utilized with the
12 RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV
touchpanel face-down onto a padded surface to prevent
scratching of the screen.
using a #1 Phillips screwdriver, tighten an additional 1/8-turn.
attach the triamese cable (supplied) connector labeled AUDIO
to the AUDIO port, the non-labeled connector to the RGB
port, and the connector labeled NET to the NET/VIDEO port.
AUDIO RGB CONNECTOR
CONNECTOR (NOT LABELED)
AUDIO
HEADPHONES RS-232
appropriate ports on the rear of the touchpanel base.
touchpanel, connect the output plug of the power pack to the
24VDC 2.0A port on the rear of the touchpanel base.
Crestron TPS-XVGA-BV
NET
CONNECTOR
RGB NET/VIDEO
LAN
Operations & Installation Guide - DOC. 5920
24VDC 2.0A