Table of Contents
Advertisement
Crestron TPS-XVGA-BV
Installation Diagram 3 of 7 - Remove RGB Port Blank Plate
CAUTION: During the next step, to prevent tearing or distorting the
touchpanel label, tighten the plate mounting screws only to the
specification described.
10. Refer to the diagram on the next page. Orient the RGB port
Operations & Installation Guide - DOC. 5920
RGB Computer Interface Card for TPS/Tilt Panel
9. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen, remove and discard the two screws that secure the RGB
port blank plate. From the inside of the touchpanel base,
remove the plate and discard.
access plate (supplied) with the offset facing the rear of the
touchpanel base and position to the inside of the touchpanel
base port. Install the two plate mounting screws (supplied),
tighten to finger-tight then, using a #1 Phillips screwdriver,
tighten an additional 1/16-turn.
RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV
9
Advertisement
Table of Contents
