Crestron TPS-XVGA-BV Operations & Installation Manual page 14

RGB Computer Interface Card for TPS/Tilt Panel
Installation Diagram 4 of 7 - Install Port Access Plate
CAUTION: To minimize possible damage during shipping, the
TPS-XVGA-BV contains packing material between the fan assembly and
the card. The packing material must be removed to prevent over-heating
of the card during operation. If not removed, refer to "Preparation" that
begins on page 5 for instructions.
NOTE: The TPS-XVGA-BV touchpanel interface connector pins are
more easily inserted by gently "rocking" the TPS-XVGA-BV side-to-side
while pressing onto connector.
11. As shown on the next page, insert the computer video connector
10 RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV
of the TPS-XVGA-BV through the RGB port on the rear of the
touchpanel base. Align the pins on the touchpanel interface
connector of the card with the touchpanel motherboard
connector. DO NOT force pins into connector. Press the
TPS-XVGA-BV until pins are fully seated. Make sure that the
screw holes of the card align with the mounting posts on the
motherboard.
Crestron TPS-XVGA-BV
Operations & Installation Guide - DOC. 5920