Network Settings Page Items - Casio XJ-UT311WN Network Function Manual

Network Settings Page Items

To do this:
Specify auto acquisition of an IP
address from the external LAN
device
Specify the IP address manually
Specify auto allocation of IP
addresses to computers and smart
devices by the projector
Specify no allocation of IP addresses
to computers and smart devices by
the projector
Enable wireless LAN connection to
the projector from a computer and/or
smart device (by enabling the built-in
access point function)
Disable wireless LAN connection to
the projector from a computer and/or
smart device (by disabling the built-in
access point function)
Enable/disable SSID broadcasting
Specify the channel for wireless LAN
communication
Specify auto selection of the wireless
LAN channel to be used
Connect the projector to an external
wireless access point
Do not connect the projector to an
external wireless access point
Perform this operation:
In the "IP Settings" area, click "Obtain an IP address automatically".
1. In the "IP Settings" area, click "Use the IP address below".
2. In the "IP Address" boxes, enter the IP address you want to assign to the
projector (Initial Default: 192.168.100.10).
3. In the "Subnet Mask" boxes, enter a value that will be used to determine
range of IP addresses of the network (subnet) to which the projector will
belong (Initial Default: 255.255.255.0).
4. In the "Default Gateway" boxes, input the IP address of the default
gateway (Initial Default: 192.168.100.10).
1. In the "DHCP Settings" area, click "Auto".
2. Specify the range of automatically allocated IP addresses as required.
 In "Starting Address" and "Ending Address", input a value in the range
of 11 to 254 for the fourth octet.
 Only the fourth octet can be specified by you. The other octets cannot
be changed.
In the "DHCP Settings" area, click "Disable".
Change the "Wireless Settings" area "Access Point Function" setting to
"Enable".
Change the "Wireless Settings" area "Access Point Function" setting to
"Disable".
In the "Wireless Settings" area, select "Enable" or "Disable" for "SSID
Broadcast".
In the "Wireless Settings" area, click [] on the right side of the "Channel"
box. On the list that appears, select a channel from 1 to 11.
In the "Wireless Settings" area, click [] on the right side of the "Channel"
box. On the list that appears, select "Auto".
In the "External Access Point" area, click "Enable" and configure settings
as required.
For details, see "To connect the projector to a wireless LAN access point
without terminating a direct wireless LAN connection with a computer"
(page 10).
In the "External Access Point" area, click "Disable".
25