Table of Contents
Advertisement
Step 1A: Quick Start Setup Procedures
Storage Device Setup (for Attached Storage Units)
If you have a NAS (SCSI Connected Storage Device or "SAN") that will be used with the
ER, you will need to connect it to the ER at this point. Refer to the Appendix at the end of
this document for instructions on how to connect the SCSI Connected Storage Device.
Link the Workstation to the ER
Monitor and Keyboard Setup
A. Connect the PC monitor and keyboard cables to the rear of the chassis.
B. Turn on the PC monitor.
C. Power on the ER by dropping down the face plate and pressing the large button at
the right of the front panel (see image below).
Once the ER is powered up, proceed to the Login screen instructions.
Serial Console Setup
A. Using the serial port cable (and USB DB9 serial adapter, if necessary), connect the
laptop to the rear of the chassis (see image below).
B. Power on the laptop.
C. Power on the ER by dropping down the face plate and pressing the large button at
the right of the front panel (see first image above).
Once the ER is powered up, proceed to the instructions for HyperTerminal Setup Proce-
dures.
Front of the 1U chassis
Rear of the 1U chassis
8
6 e
r
Q
e
nterprise
eporter
uick
s
G
tart
uide
Advertisement
Table of Contents
