Wavetek MS1200 Operation Manual page 22

Use the up or down arrow to highlight the desired parameter. Press
the key to edit the selected parameter. After completing your
entry, be sure to press the
Enabled
As mentioned earlier, a channel must be enabled in order
for it to be measured. This is another place where you can
enable or disable the channel.
Type
There are three channel types from which to choose:
Frequency
This is the frequency of the video carrier in MHz.
Channel Number
The channel number can range from 1 to 999.
Label
You can enter a label up to four characters in length for
each channel. This label appears next to the channel
number on most screens to help you to remember what
programming is on that channel.
Package
You can organize channels into packages. In the edit box,
you can select any package that is enabled (see the section
on CHANNEL PACKAGES). When you are checking an
installation, you can specify which packages the subscriber
has ordered and your microStealth will verify that the
channels are correctly installed.
Scrambled
If the channel is scrambled, select YES here so that accu-
rate measurements can be made.
22
key again.
TV -the standard video and audio carriers
DUAL -a video carrier with two independent
audio carriers (a European format)
SNGL -a single carrier