Wavetek MS1200 Operation Manual page 20

Step 1
You are asked to enter a name for the channel plan. Using
the edit box, you can enter any name up to fifteen charac-
ters long. Be sure to terminate your entry with the
Press the
Step 2
There are several standard channel plans to use as a
foundation for building your plan. Use the up or down
arrows to highlight the one that is appropriate for your
system. Press the
step.
Step 3
You can tell microStealth what frequency to stop searching
for channels. This will save time when building the plan.
The frequency you enter should be just above the highest
channel on your system. If you are not sure what the
frequency of your highest channel is, just use the default
value that appears in the edit box. If you have entered a
value, be sure to terminate your entry with the
Press the
Upon pressing the
system for active channels. A bar graph indicates the percentage of
the channels searched. After the plan has been built, press the
soft key to return to the Channel Plan Configuration screen.
EDIT CHANNEL PLAN
You can edit various parameters for each channel. Press the
key to edit the channels. A list of all the channels in the plan
appears.
20
soft key to continue with the next step.
soft key to continue with the next
soft key to begin building the plan.
soft key, microStealth begins searching your
key.
key.