Table of Contents
Advertisement
MENU (SCREEN) PAGE #2
NOTE: These commands require that the unit be in REMOTE mode with the serial interface in
control. See screen (menu) page #1 key 'F2' bytes 9 & 13.
Parameters : >00AQSWT0 A0.0O43.1
Alt-X to exit
Copyright 1995.
F1
F2
F1, F2 & F8 - N/A (not available)
F3 - Prevents the unit from going to LOCAL mode. This is to be used with rack-mount unit
where the operator requests to go local and the control room wants to lock out the operator.
F4 - Puts the unit in AUTO mode.
F5 - Puts the unit in MANUAL mode.
F6 - Sets switch so that output goes to Antenna. (Unit must be in MANUAL mode).
F7 - Sets switch so that output goes to RF load. (Unit must be in MANUAL mode).
F9 - Sets user defined threshold. This should be a value from 300 to 500 representing 30.0 to
50.0 dBm. When the output level falls below this level an alarm will be generated.
F10 - 'MORE' goes to next menu (screen) page.
ADVANTECH - Advanced Microwave Technologies, Inc.
Address
: 0
PAGE - 2 -
F3RemoteF4
Auto F5ManualF6SWAnt
Figure 9: Page #2 of the Communication Program
ARMA-C250-CRM
PROTOCOL: ADV, 9600, E
F7SWLoadF8
F9ThreshF0
Rev 1.40
More
33
Advertisement
Table of Contents
