Table of Contents
Advertisement
MENU (SCREEN) PAGE #1
NOTE: Commands 'F5', 'F6', 'F7' & 'F8' require that the unit to be in REMOTE mode. See
key 'F2' bytes 9 & 13 below.
ADVANTECH - Advanced Microwave Technologies, Inc.
Address
Leds info
Message
Parameters : >00AP A0.0 C112.8 M20.0 O43.1 R17.3 TM49.2 TS28.6
Alt-X to exit
Copyright 1995.
F1ID&SerF2
Leds F3MessagF4Param F5Reset F6MUTEonF7MUTEofF8Atten F9Unit#
F1 - Queries the unit for ID and serial number.
F2 - Queries the unit for LEDs information. These are the digital outputs of the unit, that
may be used to light LEDs. After disregarding the header, following the 'L' the bytes
('0' or '1') represent
1. '1' - The unit is powered. (Will always be '1')
2. '1' - RF output power detected.
3. '1' - Alarm condition exists
4. '1' - Fault condition exists
5. '1' - This unit is connected to the antenna (ON-LINE)
6. '1' - This unit is connected to an RF load (STDBY)
7. '1' - The unit shutdown by operator (MUTE)
8. - No info
9. '1' - unit under remote control / '0'- LOCAL control
10. 'S'
11. '1' - A message is available / '0'- no messages
: 0
: >00AL110010 011 S001 00#K
: >00AM#P
PAGE - 1 -
Figure 8: Page #1 of the Communication Program
ARMA-C250-CRM
PROTOCOL: ADV, 9600, E
Rev 1.40
F0
More
31
Advertisement
Table of Contents
