Table of Contents
Advertisement
Leading Specifications
Setup
Operations Guide - Doc. 5694
CRESTRON
The table below provides a summary of leading specifications for the ST-LT
module. Dimensions and weight are approximations rounded to the nearest
thousandth unit.
Leading Specifications of the ST-LT
SPECIFICATION
Power Requirements
Power Factor
CRESNET II Workshop
SIMPL Compiler
CRESNET II Operating System
SmarTouch Operating System
TM
STS VisionTools
for Windows (STS/VTW)
STS Database
Dimensions & Weight
As of the date of manufacture, the unit has been tested and found to comply with
specifications for CE marking.
Identity Code
Every equipment and user interface within the CRESNET II requires a unique
identity code (NET ID). These codes are recognized by a two-digit hexadecimal
number from 03 to FE. The NET ID of each unit must match an ID CODE specified
in the "NET.ID" statement of the CRESNET II SIMPL-I program in order for the
device to be addressed properly. The NET ID of each ST-LT has been factory set to
1C, but may be changed from the PC via STS/VTW software or the CRESNET II
Workshop.
Change NET ID via STS/VTW Software
Attach the ST-LT to SmarTouch STS or CRESNET II system (verify that the
STS/VTW software is running) and complete the following steps to change the NET
ID.
1. Disconnect all network devices from the CRESNET II network or
modular devices from the STS system, except for the one ST-LT that
needs to have its NET ID code changed.
2. Select ViewPort from the Tools pull-down menu to open the "Crestron
Performance Viewport" dialog box.
3. Select Set Network ID from the Options pull-down menu. The software
checks the baud rate and then opens the "Set Network ID" dialog box.
DETAILS
12 or 24 VDC
2.5 Watts
Version 5.24 or later
3.18.04 or later
3.17.31 or later
Any
Version 10.7 or later
Version 10.7.100.02 or later
Height: 1.700 in (4.318 cm)
Width: 7.066 in (17.948 cm)
Depth: 6.322 in (16.058 cm)
Weight: 2.100 lb (0.953 kg)
Lutron Interface • 5
Advertisement
Table of Contents
