Programming - Crestron ST-LT Operation Manual

Alternatively, the ST-LT can
be selected by choosing
Lighting, Lutron, and
GRAPHIK Eye via ST-LT in
the appropriate fields.
10 • Lutron Interface
CRESTRON

Programming

Using STS/VTW Software
NOTE: The following description assumes that the reader has some knowledge of
STS/VTW software. If not, please refer to the SmarTouch Tutorial that is available
from the STS/VTW Help menu.
Use STS/VTW software (version 10.7 or higher and STS database version
10.7.100.02 or later) to include the ST-LT in lieu of a Lutron GRAFIK Eye device
into a SmarTouch system. Once included, a command sequence or macro must be
enabled via software. The macro prompts which MAIN-UNIT is controlled and
dictates which actions are to be followed. The procedural steps that follow this
paragraph provide the general course necessary to include the ST-LT into a
SmarTouch system and build and assign a macro.
1. Select Open and Smartouch System from the File menu to open a
specific SmarTouch system. The software displays the "SmarTouch
Pro Editor" dialog box (formally known as "SmarTouch System
Manager").
2. Double click on the next available open device (DEVICE #) in the
Devices section of the dialog box. The software displays the "Device
Selection and Configuration" dialog box.
3. Define the device by selecting the Crestron Database, Lighting (as the
type), Crestron (as the manufacturer), and ST-LT (as the Model). For
this sample, replace DEVICE # with ST-LT in the [Name:] field. By
default, a Net ID of 1C is assigned. The dialog box should appear as
shown below; click OK.
Device Selection and Configuration Dialog Box
4. Once the ST-LT has been added to the SmarTouch system,
functionality must be assigned to buttons residing on a lighting page.
Operations Guide - Doc. 5694