Page 1
BMW i8 Style Kids Ride on Car Installation and Operation Instructions Please read this instruction manual carefully. It is important to read and follow all of the steps during assembly to ensure proper operation and safety of the child. Please keep this manual for future reference.
Installing Front Wheels Place a washer onto the axle shaft. Insert bushing into both sides of wheel and slide wheel onto the axle shaft Place another washer onto the axle shaft and slip the cotter pin through hole in axle and spread ends of cotter pin to secure the assembly.
Installing the Seat Prior to installing the seat it is necessary to connect the battery. Locate the wire with slide terminal crimped on one end. Slip the slide terminal over the spade terminal on the battery. Set the seat in the appropriate position on the car.
Page 6
come on accompanied by the sound of the engine. To allow child to operate the car, remote control/manual switch has to be set to the manual position. To move the car forward, goahead/back switch has to be set to the goahead position and to move the car backward, the switch will need to be set to the back position.
IMPORTANT REMINDERS: • Prior to first use of this electrical vehicle, please charge the battery for a minimum of 12 hours. Failure to complete this step will cause permanent damage to the battery. • Do not operate on streets, roads, steep slopes, through ditches or in any dangerous areas.
TROUBLE SHOOTING GUIDE: Problem Possible Cause Possible Solutions Car will not move Battery voltage is low. Charge the battery Screw on the wheels may Re-tighten screws on have come loose. wheels. Battery connector may have come apart or have Re-connect the battery a bad connection.
Need help?
Do you have a question about the BMW i8 Style and is the answer not in the manual?
Questions and answers