Hyundai Coupe Tiburon 2005 Owner's Manual page 447

1. Keep all tyres inflated to the cor-
rect pressure.
2. Place the vehicle on level ground
and press the front bumper & rear
bumper down several times. Place
vehicle at a distance of 118.1 in.
(3m) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tyres,
jack, and tools).
4. Clean the head lights lens and turn
on the headlight.
5. Open the bonnet.
6. Draw the vertical line (through the
centre of each headlight beam pat-
tern) and the horizontal line (through
the centre of each headlight beam
pattern) on the aiming screen.
And then, draw a parallel line at
1.18 in. (30 mm) under the hori-
zontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a
phillips screwdriver - VERTICAL
AIMING.
8. Adjust each cut-off line of the low
beam to the each vertical line with
a phillips screwdriver - HORIZON-
TAL AIMING.
gkfluk-6.p65 29
G290B01GK-EAT
Adjustment After Headlight As-
sembly Replacement
Vertical line
Horizontal line
W
"P"
1.18 in.
Cut-off line
H
L Ground
line
H
G290B01JM-D
If the vehicle has had front body
repair and the headlight assembly
has been replaced, the headlight aim-
ing should be checked using an aim-
ing screen as shown in the illustra-
tion. Turn on the headlight switch.
1. Adjust headlights so that main axis
of light is parallel to centre line of
the body and is aligned with point
"P" shown in the illustration.
2. Dotted lines in the illustration show
centre of headlights.
11/21/2005, 3:01 PM
OWNER MAINTENANCE
SPECIFICATION:
"H"
Horizontal centre line of headlights
from ground:
Low Beam: 26.7 in. (679mm)
High Beam: 26.5 in. (672mm)
"W"
Distance between each headlight cen-
tre : Low
Beam: 47.3 in. (1,202mm)
High Beam: 38.0 in. (966mm)
"L"
Distance between the headlights and
the wall that the lights are tested
against : 118.11 in. (3,000 mm)
6
29