Hyundai Coupe Tiburon 2005 Owner's Manual page 398

3
IN CASE OF EMERGENCY
8
ZD070F1-E
3. Loosen Wheel Nuts
HGK4013
The wheel nuts should be loosened
slightly before raising the car. To loosen
the nuts, turn the wrench handle coun-
terclockwise. When doing this, be sure
that the socket is seated completely
over the nut so it cannot slip off. For
maximum leverage, position the
wrench so the handle is to the right as
shown in the drawing. Then, whilst
holding the wrench near the end of the
handle, pull up on it with steady pres-
sure. Do not remove the nuts at this
time. Just loosen them about one-half
turn.
gkfluk-3.p65 8
D060E01A-AAT
4. Put the Jack in Place
HGK4012
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the illustra-
tion.
11/21/2005, 3:02 PM
SD070G1-E
5. Raising the Car
Wrench bar
Wheel
nut
wrench
HFC4022
After inserting a wrench bar into the
wheel nut wrench, install the wrench
bar into the jack as shown in the draw-
ing. As the jack begins to raise the
vehicle, double check that it is properly
positioned and will not slip. If the jack
is on soft ground or sand, it may be
necessary to place a stout piece of
timber under the base of the jack to
prevent it from sinking.
Raise the car high enough so that the
fully inflated spare tyre can be in-
stalled.