Hyundai Coupe Tiburon 2005 Owner's Manual page 40

1
FEATURES OF YOUR HYUNDAI
26
B230G01A-GAT
Installation on the Outboard Rear
Seats
On outboard rear seats
HGK1010
To install a child restraint system in the
outboard rear seats, extend the shoul-
der/lap belt from its retractor. Install
the child restraint system, buckle the
seat belt and allow the seat belt to take
up any slack. Make sure that the lap
portion of the belt is tight around the
child restraint system and the shoulder
portion of the belt is positioned so that
it cannot interfere with the child's head
or neck. After installation of the child
restraint system, try to move it in all
directions to be sure the child restraint
system is securely installed.
If you need to tighten the belt, pull more
webbing toward the retractor. When you
unbuckle the seat belt and allow it to
retract, the retractor will automatically
revert back to its normal seated pas-
senger emergency locking usage con-
dition.
NOTE:
o Before installing the child re-
straint system, read the instruc-
tions supplied by the child re-
straint system manufacturer.
o If the seat belt does not operate
as described, have the system
checked immediately by your
authorized Hyundai dealer.
!
WARNING:
Do not install any child restraint
system in the front passenger seat.
Should an accident occur and cause
the passenger side airbag to de-
ploy, it could severely injure or kill
an infant or child seated in an infant
or child seat. Therefore, only use a
child restraint system in the rear
seat of your vehicle.
B230B02GK-GAT
Using a Child Restraint System
with "Tether Anchorage" Sys-
tem
Hook Holder
Bolt, Holder (5/16"-22 mm)
Washer, Conical Spring
Holder, Child Restraint Hook
Spacer, Hook Holder Cover
Spacer (10 mm),
Child Restraint Hook Holder
Retainer Washer
HGK264
For small children and babies, the use
of a child seat or infant seat is required.
This child seat or infant seat should be
of appropriate size for the child and
should be installed in accordance with
the manufacturer's instructions. It is
further required that the seat be placed
in the vehicle's rear seat since this can
make an important contribution to
safety. Your vehicle is provided with
two child restraint hook holders for
installing the child seat or infant seat.